- Drying usually takes longer than washing, so dryers often need more capacity than washers to keep up. Size them on their own cycle time.
- Three main heating types: electric (simple to install, needs a big electrical supply), gas (needs a gas supply, flue or vent, and a Gas Safe registered engineer or competent person, as HSE explains) and heat pump (recirculates warm air; ask about cycle times and condensate drainage).
- Vented dryers need ducting to outside, sized and routed as the manufacturer specifies; long or blocked ducts slow drying and raise temperatures.
- HSE says work on gas fittings in workplaces such as shops, restaurants, schools and hospitals must be carried out by a Gas Safe registered engineer who is qualified for it.
- Lint builds up in filters and ducts. Clean it as the manufacturer says, and include dryers in your fire risk assessment, which the Fire Safety Order requires the responsible person to make.
- A faster washer spin leaves less water in the laundry, which shortens drying: compare washers and dryers as a pair.
Which type of commercial tumble dryer is best?
Electric dryers are simplest to install if you have the electrical capacity; gas dryers need a gas supply and flue but suit sites with gas; heat pump dryers recirculate warm air and suit sites where venting is hard. The best choice depends on the supply you have, venting, how much you dry and your running costs.
| Type | How it heats | Installation needs | Ask about |
|---|---|---|---|
| Electric (vented) | Electric elements heat incoming air; moist air is vented outside | A large electrical supply (often three-phase) and ducting to outside | Supply needed, cycle times, running cost for your loads |
| Gas (vented) | A gas burner heats the air; exhaust is vented outside | Gas supply, flue/vent and air supply to the room, installed by a Gas Safe registered engineer or competent person (HSE) | Gas rate, ventilation, servicing of the burner |
| Heat pump | A heat pump heats and dries recirculated air | Usually no outside vent, but a drain for condensed water | Cycle times, room temperature, filter cleaning |
How big should commercial tumble dryers be?
Big enough to dry everything your washers produce in the same working day. Because a dry cycle is often longer than a wash cycle, that usually means more dryer capacity than washer capacity, either bigger dryers or more of them.
- Use the dryer's own cycle timeDrying time depends on the item, how wet it comes out of the washer and the dryer itself.
- Wetter laundry dries slowerA washer that spins harder leaves less water to remove, which shortens drying.
- Bulky items need spaceDuvets, towels and rugs need room to tumble; a full drum dries slowly.
- Some items can't be tumble driedFollow care labels. Heat-sensitive items may need low heat or air drying.
Our laundry capacity calculator sizes washers and dryers separately, using the cycle times you enter.
What rules apply to gas tumble dryers?
Gas dryers must be installed and worked on by someone competent, which HSE says in workplaces such as shops, restaurants, schools and hospitals means a Gas Safe registered engineer qualified to do the work, and employers must keep gas appliances, pipework and flues at their workplace in a safe condition.
- Competent people only"No person shall carry out any work in relation to a gas fitting or gas storage vessel unless he is competent to do so" (Gas Safety Regulations 1998, regulation 3).
- Gas Safe registeredHSE: in workplaces such as shops, restaurants, schools and hospitals, work on gas fittings must be carried out by a Gas Safe registered engineer who is qualified to do the work (HSE).
- Kept in a safe conditionEmployers and the self-employed must ensure gas appliances, installation pipework and flues at a place of work under their control are "maintained in a safe condition so as to prevent risk of injury to any person" (regulation 35).
- VentilationGas dryers need air to burn and a safe route for exhaust. The installer should check the room's ventilation and the flue or vent.
How should a commercial tumble dryer be vented?
Through ducting to outside, at the size, length and number of bends the manufacturer allows, with a suitable outlet. Ducts that are too long, too narrow or blocked with lint slow drying and can make the dryer run hot.
Good venting
- Duct size and run as the manufacturer specifies
- Smooth, cleanable ducting with as few bends as possible
- An outlet that doesn't let lint build up
- Enough fresh air into the room
Warning signs
- Drying taking longer than it used to
- Hot room or hot dryer cabinet
- Lint around the outlet or doors
- Several dryers sharing a duct not designed for it
How do you reduce the fire risk from commercial dryers?
Clean lint filters as often as the manufacturer says (often every load or every shift), keep ducts clean, don't leave dryers running unattended if the manufacturer advises against it, and let loads cool down before stacking them. Include the laundry in your fire risk assessment.
- Lint filtersClean them at the intervals the manufacturer sets. A clogged filter slows drying and raises temperatures.
- Ducts and the dryer's interiorHave lint removed from behind the drum and ducts at service visits.
- Cool-downUse the cool-down phase at the end of a cycle, and don't pile hot laundry in a trolley straight from the dryer.
- Oils and contaminationLaundry contaminated with oils (for example from kitchens, spas or massage) needs proper washing before drying; ask your chemical and machine suppliers how to handle it.
- Fire risk assessmentIn England and Wales, the responsible person for business premises "must make a suitable and sufficient assessment of the risks" to identify the fire precautions needed (Fire Safety Order 2005, article 9). Laundries and dryers belong in it.
What servicing do commercial tumble dryers need?
Regular cleaning by your staff (filters), and planned servicing by an engineer: drum, belts and bearings, door seals, heating, sensors, lint removal and, for gas dryers, the burner and flue.
Employers must keep work equipment "maintained in an efficient state, in efficient working order and in good repair" (PUWER regulation 5), and gas appliances in a safe condition (regulation 35 above). In care homes, HTM 01-04 says items should go through a drying process where they are compatible with it, then be stored in a clean area above floor level (Social care volume, 6.12), so a dryer breakdown matters there too. Ask suppliers what a service visit includes and how quickly they respond to breakdowns. See our repair and servicing guide.
What affects the price of a commercial tumble dryer?
Capacity, heating type, controls (such as moisture sensing and programmable temperatures), the installation work (electrics, gas, ducting) and how you pay. Running costs depend heavily on how wet laundry arrives from the washer.
- Capacity and heatingLarger and gas or heat pump models are priced differently from electric ones.
- ControlsMoisture sensing, programmable temperatures and cool-down control.
- InstallationElectrical supply, gas work, ducting and any building work.
- Washer spinBetter extraction upstream can cut drying time and energy.
Get quotes for commercial laundry equipment
Tell us about your laundry once. We pass it to a specialist UK commercial laundry equipment supplier, who will:
- Talk through your laundry: what you wash, how much, the space you have, and your water, drainage, power and any gas.
- Quote in writing to buy, lease or on a monthly plan, with delivery, installation and servicing shown.
- Explain the service cover: response times, what's included, and who to call when a machine stops.
For businesses and organisations. Prefer email? Write to [email protected] with your business type, size and the machines you need.
Related guides
Commercial tumble dryers: frequently asked questions
Is a gas or electric commercial tumble dryer better?
It depends on your site. Electric dryers are simpler to install where there's enough electrical capacity; gas dryers need a gas supply, a flue and a Gas Safe registered engineer or competent person (HSE). Compare running costs for your loads using each supplier's figures.
Do commercial tumble dryers need to be vented?
Vented electric and gas dryers need ducting to outside, installed as the manufacturer specifies. Heat pump dryers usually recirculate air and need a drain for condensed water instead of an outside vent.
Who can install a commercial gas tumble dryer?
HSE says work on gas fittings in workplaces such as shops, restaurants, schools and hospitals must be done by a Gas Safe registered engineer who is qualified for that work.
Why does my commercial dryer take longer than it used to?
Common causes include a blocked lint filter or duct, laundry coming out of the washer wetter than before, overloading, or a fault with heating or sensors. Clean the filter and call an engineer if it doesn't improve.
How often should I clean the lint filter?
As often as the manufacturer says, which is often every load or every shift. Have ducts and the area behind the drum cleaned at service visits.
Should my dryers be bigger than my washers?
Often, yes, because drying usually takes longer than washing. Size dryers on their own cycle time so they can dry everything your washers produce in the working day.
Can I put a commercial dryer on top of a washer?
Some commercial machines are made as stacked washer-dryers or stacked double dryers. Only stack machines designed and approved to be stacked.
Sources
We checked the facts on this page against these sources on 18 November 2026. Guidance changes: check the current version before you rely on it.
- Gas Safety (Installation and Use) Regulations 1998, regulation 3: qualification and supervision (legislation.gov.uk)
- Gas safety for employers (HSE)
- Gas Safety (Installation and Use) Regulations 1998, regulation 35: duties of employers (legislation.gov.uk)
- Regulatory Reform (Fire Safety) Order 2005, article 9: risk assessment (legislation.gov.uk)
- Provision and Use of Work Equipment Regulations 1998, regulation 5: maintenance (legislation.gov.uk)
- HTM 01-04: Social care volume (NHS England, PDF)